TI 公司的CC1120是 全集成的868/915MHz單片無線電收發器，主要用在窄帶超低功耗無線系統，無線計量和無線智能電網（AMR和AMI），IEEE 802.15.4g系統，家庭和建筑物自動化，工業控制，無線保健，無線傳感器網絡和有源RFID，私人移動無線電等。本文介紹了CC1120開發套件主要特性和組成，SmartRF收發器評估板(TrxEB)主要特性，和EM連接圖，SmartRF TrxEB架構圖以及SmartRF TrxEB 1.3.0和1.5.0電路圖。
The CC1120 development kit provides a complete hardware performance testing and software development platform for TI’s Sub-1 GHz Performance Line devices. The development kit comes with a pre-programmed packet error rate test. RF range and robustness can be tested with different RF settings, and power consumption can be measured easily. This kit supports 868MHz and 915MHz. Additionald Evaluation Module Kits can be purchased separately to support other frequencies.
CC1120開發套件
The CC1120 development kit provides a complete hardware performance testing and software development platform for TI’s Sub-1 GHz Performance Line devices. The development kit comes with a pre-programmed packet error rate test. RF range and robustness can be tested with different RF settings, and power consumption can be measured easily. This kit supports 868MHz and 915MHz. Additionald Evaluation Module Kits can be purchased separately to support other frequencies.
The kit includes the SmartRF Transceiver Evaluation board (TrxEB), which has a number of useful features for development of prototype software, as well as USB connectivity making it possible to connect the board to a PC and control the radio from SmartRF Studio. In short, the TrxEB includes
MSP430F5438 MCU
USB interface
128 x 64 dot matrix LCD
3 axis digital accelerometer
Ambient light sensor
The software examples provided with the kit can be used as a basis for working with the Transceiver Evaluation Board and the connected radio.
圖1。CC1120開發套件外形圖
CC1120開發套件主要特性：
CC1120開發套件包括：
2 x SmartRF Transceiver EB (TrxEB)
2 x CC1120EM 868/915 MHz
2 x Pulse Antennas
1 x MSP430 Debug Probe (FET)
2 x Micro USB Cables
1 x Standard USB Cable
1 x 14-pin Flat Cable
4 x 1.5 Volt AA Batteries
Documentation
SmartRF收發器評估板(TrxEB)
The kit includes the SmartRF Transceiver Evaluation board (TrxEB), which has a number of useful features for development of prototype software, as well as USB connectivity making it possible to connect the board to a PC and control the radio from SmartRF Studio. In short, the TrxEB includes
MSP430F5438 MCU
USB interface
128 x 64 dot matrix LCD
3 axis digital accelerometer
Ambient light sensor
The software examples provided with the kit can be used as a basis for working with the Transceiver Evaluation Board and the connected radio.
SmartRF收發器評估板(TrxEB)主要特性：
Kit contents:
2 x SmartRF Transceiver EB (TrxEB)
2 x CC1120EM 868/915 MHz
2 x Pulse Antennas
1 x MSP430 Debug Probe (FET)
2 x Micro USB Cables
1 x Standard USB Cable
1 x 14-pin Flat Cable
4 x 1.5 Volt AA Batteries
Documentation
SmartRF收發器評估板(TrxEB)
The SmartRF TrxEB is a flexible test and development platform that works together with RF Evaluation Modules from Texas Instruments.
An Evaluation Module is a small RF module with RF chip, balun, matching filter, SMA antenna connector and I/O connectors. The modules can be plugged into the SmartRF TrxEB which lets the PC take direct control of the RF device on the EM over the USB interface.
Currently, SmartRF TrxEB supports:
- CC1120EM
- CC1121EM
- CC2520EM
- CC1101EM
- CC1100EM
- CC1100EEM
- CC110LEM
- CC113LEM
- CC115LEM
SmartRF TrxEB is included in e.g. the CC1120 development kit. Some of the above EMs comes in variants combined with a RF front-end such as CC1190 or CC2590/CC2591. Such variants are called combo EMs and are also supported by the SmartRF TrxEB. See chapter 8 for details on how to use SmartRF TrxEB rev. ≤1.5.0 to control a combo EM using SmartRF Studio.
圖2。SmartRF收發器評估板(TrxEB rev. 1.5.0)和EM連接外形圖
圖3。SmartRF TrxEB架構圖
圖4。SmartRF TrxEB 1.3.0電路圖（1）
圖5。SmartRF TrxEB 1.3.0電路圖（2）
圖6。SmartRF TrxEB 1.3.0電路圖（3）
圖7。SmartRF TrxEB 1.3.0電路圖（4）
圖8。SmartRF TrxEB 1.3.0電路圖（5）
圖9。SmartRF TrxEB 1.3.0電路圖（6）
圖10。SmartRF TrxEB 1.3.0電路圖（7）
圖15。SmartRF TrxEB 1.5.0電路圖（1）
圖16。SmartRF TrxEB 1.5.0電路圖（2）
圖17。SmartRF TrxEB 1.5.0電路圖（3）
圖18。SmartRF TrxEB 1.5.0電路圖（4）
圖19。SmartRF TrxEB 1.5.0電路圖（5）
圖20。SmartRF TrxEB 1.5.0電路圖（6）
圖21。SmartRF TrxEB 1.5.0電路圖（7） |
